www.MG42.us

Hi; Guys just finish a semi zb37 its off to teck for approvel
runs great put 900 rounds down range not one prob also have a gas gun at teck
it will be great for renactors it will be a non firearm

you have a common prob. the buffer needs to be mechined,the bolt has to hit the edj. spool plus about .100 cl. mark the rec. where the bolt hits the edj. spool after mechineing you need you should have .100cl to set spring length remove buffer guts install bolt and spring ,bolt should pull back to t...

first take out the recop and see if the bbl will unlock when you hold it up should unlock by its own weight when you hold it down the bolt should slide by its own weight and lock, you must meet this condition.the bbl. will move 8mm from lock to unlock. if all is good the ch handle may be in a bind t...

sorry forgot to tell you ,youhave to extend the part that hits the edj. forward to account for the extra length my error

Hi, well what you need yo do when its not moving is heat a small spot about the size of your little finger a dull red then quench in cold water use a 5gal. bucket some times you have to do it twice. Headspace on a 42 is totaly differnt. remove extracor insert a 8mm or 308 live in bbl insert bolt set...

sorry guys but its longer so the bolt ext. dosent hit the buffer you still have to cut the spring

Hi Bob, i dont have pix but if you measure the dim. you will find the spot where you only need to strech it a bit no too front ends are the same i took 6 in. out and you could tell if the guns were side by side it looks like a lot of taper but its only the way it looks the trick is to get the slots ...

see my post 42

i have shorten the bbl jacket take it out of the center if you get the right spot it will fit with no over lap when you weld use a bbl. to keep it allined. then grind the welds for finish. the last thing you do is reinstal bbl. and heat to a dull red about one inch each side of the weld, the front o...

dont rember how maney paid with mo. 32 dollers
gordie k

wiselite uses the .154 pin and its a slight press fit
gordie k

Hi; well first check to see if the cocking handle and the tab on the bolt slide up and down when you pull the handle to the rear it tends to ride up ,if the angle is wrong it will bind ,also the tab on the bolt often binds in the receiver but only under spring pressur. when you pull the bolt to the ...

PM sent

The charging handle needs to have a slight angle ground on the front lip so it tends to ride into the bolt. also remove the radis on the inside. on the bolt the lip the handle grips needs a slight angle so the lip of ch. tends to ride down onto the bolt
gordie k

MGS had top covers for the mg15 drums they were about 250

dont know about rollers but the clips are aveable from bearing supply houses

like anything it needs a little tlc to get it to run but when it dose you will more than satafied

I have recop. springs, need to know single or double
PM me and i"ll send you what you need

Hi; i would be intersted i 5 but need to see your ans. to tony , to see if thes will work in my guns

if its for the recop. i have some the double ones glad to help
gordie k