Having an issue with gmt shells and m53 rear end

Ask your build questions here. Welding, assembly, etc.
Post Reply
Opie7afe
Hauptgefreiter
Hauptgefreiter
Posts: 5
Joined: Wed Mar 07, 2018 9:46 pm
Anti-spam: Mg42

Having an issue with gmt shells and m53 rear end

Post by Opie7afe »

I'll start this out by saying I'm not bashing gmt.they are good shells just not lining up how I need them..would be perfect if I was doing the buffer cuts and tabs which I'm not.

I have the receiver in spec to width of the rear section which is 2.196. any ideas on what to do regarding the difference in the charging handle slot of the m53? Gmt shells and m53 rear section..just don't want to blow through the receiver when I cut the charging handle slot.. everything else is square and dead on. Thanks in advance.
Image
Image
Post Reply