Looking for a full rear section with receiver rail dimples

Ask your build questions here. Welding, assembly, etc.
Post Reply
planejack777
Oberstabsgefreiter
Oberstabsgefreiter
Posts: 33
Joined: Wed Oct 27, 2010 5:55 pm
Anti-spam: Mg42

Looking for a full rear section with receiver rail dimples

Post by planejack777 »

Hey Everyone:
I’m getting started on this build, perhaps too late (Story of my life), however I’m looking for a full rear section (80% I guess I need to say) that has the Receiver Rail dimples in it. It appears that now I’ve started to search...that either that detail was deleted from those selling them...or the Receiver halves are all but non-existant anymore. Can anyone enlighten me as to what is now available....or anyone who may wish to sell that which they no longer may need?

Regards,
Jack
42rocker
Administrator
Administrator
Posts: 3251
Joined: Fri Jan 11, 2008 6:03 pm
Anti-spam: Mg42
Location: Florida

Re: Looking for a full rear section with receiver rail dimples

Post by 42rocker »

Jack
I believe that most of the current receiver makers do not include those rivet dimples.
Anyone seen anyone making a receiver with them?

Later 42rocker
Abominog
Major
Major
Posts: 314
Joined: Tue Apr 05, 2005 1:03 pm

Re: Looking for a full rear section with receiver rail dimples

Post by Abominog »

No dimples you can drill them yourself for cosmetics.

Use the BRP two piece shell. I think RTG has them in stock. Hope you can weld and mill.
FNG
42rocker
Administrator
Administrator
Posts: 3251
Joined: Fri Jan 11, 2008 6:03 pm
Anti-spam: Mg42
Location: Florida

Re: Looking for a full rear section with receiver rail dimples

Post by 42rocker »

Also the term 80% got axed by batf. Now using 70% and other fun terms.
Review the link that I sent you. The rebuild is lots of work. Might be better off to go the 3 cut yugo receiver route.

Later 42rocker
Post Reply