I did a run of these awhile back through a local machine shop, they went pretty fast here on the forum. I have a few left for my own use, but am getting some recent PM's about folks needing them. What kind of interest would there be in another run of these? These work great if your receiver has been welded a little too long and you're not getting contact between the trigger gate and the existing sear. Easiest way for me to keep track is probably just replying to the thread rather than a PM, if it looks good I'll try to get another batch of these made up. Chris....
Here is the link to the photos and prices of the previous run I did....
viewtopic.php?f=17&t=8939
Gauging interest on another run of longer trip levers/sears
-
- Oberst
- Posts: 539
- Joined: Mon Feb 27, 2006 4:01 pm
- Location: Idaho
Re: Gauging interest on another run of longer trip levers/sears
I'd be in for 2 of them!
Re: Gauging interest on another run of longer trip levers/sears
I'd be in for one. Thanks.
-
- Oberst
- Posts: 539
- Joined: Mon Feb 27, 2006 4:01 pm
- Location: Idaho
Re: Gauging interest on another run of longer trip levers/sears
Everything is rolling for another run of these, should be about 2-3 weeks before I have them back in hand. Chris...
-
- Oberst
- Posts: 539
- Joined: Mon Feb 27, 2006 4:01 pm
- Location: Idaho
Re: Gauging interest on another run of longer trip levers/sears
Sear/Trip levers are in.... Machine shop charged a little more for this run, but not too bad. My Previous prices were 29$ for one, and 26$ for each additional. This included free shipping...and still does. New prices are 32$ for one shipped, and 29$ for each additional, only 3$ more per sear/trip lever. I'll start going through my PM's and responses to the thread and replying to all who have previously contacted me with all payment info, etc. Whatever is left I'll put up on the F/S section. Thanks, Chris..