Camming cut outs in receiver

The #1 place for MG42 answers.
Post Reply
User avatar
NickD
Oberstabsgefreiter
Oberstabsgefreiter
Posts: 30
Joined: Fri Aug 11, 2017 2:38 pm
Anti-spam: Mg42

Camming cut outs in receiver

Post by NickD »

Hello,
I would appreciate any help with a diagram, measurements, photos of when the camming section cutouts have to be. I have a cold steel sol. receiver I need to weld to my front half of the receiver, and I want to know where the camming cutouts on the side need to be so I know where to cut off the excess metal from the Cold Steel receiver and where to make the cutouts. Thank you in advance.
20171119_174706[1].jpg
42rocker
Administrator
Administrator
Posts: 3251
Joined: Fri Jan 11, 2008 6:03 pm
Anti-spam: Mg42
Location: Florida

Re: Camming cut outs in receiver

Post by 42rocker »

NickD
I wish you the best of luck with the cold steel receiver. Not to many folks have been able to get that one up and running.
There is a lot of info on this site, use your search button.
That said someone has gone above the call of duty, Brian at brp and post lots of great info. Check it out.

http://www.brpguns.com/mg42-semi-receiver-parts/

Good Luck again.

Later 42rocker
Post Reply