www.MG42.us

Here is a drawing showing the major dimensions needed for re-welds.
All NFA rules apply.

You can see the full size drawing here: http://www.autochart.com/MG34/MG34RecBasicDim.jpg

Thank you for posting this ...

Yes,thanks,Orin.I tried to do this once and made a mess of it. It will be handy when I try to figure out if I have enough material for a receiver. ---bil

Glad to help guys. Let me know if you need any other dimension.

Orin

As said before MANY THANKS for posting this...

Sorry that I missed out on your mg42 receiver cut sale....

Thanks Later 42rocker

Thanks 762x51 for posting the good info

Does anyone know if any 34 rec ordnance drawings exist for all the dims of the 34 rec to scratch build one???

C

There has been several good posts on this website about making one. However that said take a good look at the following website

http://www.tnwfirearms.com/photos.shtml

Note the equipment that they use to make the receivers. There has been talk about edm equipment and other things being used. I wish you a lot of luck.

Lots of folks buy several mg34 cut receivers and re-weld them...

Later 42rocker

for prints,try Maschinengewehr34.com Glenn Fahrquhar He sold some sets here,









i have one somewhere,but as mentioned above,the expensive machinery used would keep most from going the avenue. ---bil

The set of prints that Fahrquhar put out are nice ones. Think long and hard before you think of starting to make a mg34 receiver from scratch. That said it's been done by several countries and at least one company.

Later 42rocker

Does anyone have the front end blue prints for the cam location and rivet holes? Thanks.

Interesting. As far as i can read blueprints this info is NOT in the J&G/ Farquist prints.

Would it not be in the TNW semi package?