Page 1 of 1

Need muzzle section of barrel shroud...

Posted: Mon May 11, 2020 3:28 pm
by daskraut
I just need the first (don't laugh) 6 or 7 inches of the shroud, a torch cut end could work if no intact pieces are around. I saw what gunbroker has, but I do not need the entire shroud. Please message me. Thanks in advance.DK

Re: Need muzzle section of barrel shroud...

Posted: Mon May 11, 2020 9:03 pm
by JBaum
Too bad you didn't want one sooner. RTG is out of stock.

Re: Need muzzle section of barrel shroud...

Posted: Mon May 11, 2020 11:27 pm
by daskraut
damn tease!!! :lol:

Re: Need muzzle section of barrel shroud...

Posted: Thu May 14, 2020 8:34 pm
by Abominog
Good thing I grabbed two of those mg3 fronts. I’ve bought them before and mr nice guy sells them then doh when I want one I don’t have one. I said I’d never sell one again. For you I may make an exception, leaving me with one. Which means of course I will absolutely need two in the future.

Also have a partial m53 kit with front shroud cut straight across very front, and a replacement Rheinmetall bearing.

And an early Mg42 front but that’s a trade item, better have something darned rare to swap, and you don’t have it

Pm me.

Re: Need muzzle section of barrel shroud...

Posted: Sat May 16, 2020 6:55 pm
by Der Alder
I have a couple that I neatly took the barrel bushing off of with a dremel...you could add that back on as RTG still sells that part. LMK if interested.