Search found 2 matches
- Wed Jun 13, 2018 3:47 pm
- Forum: MG42 Build It Yourself
- Topic: Looking for help with the global machining receiver sections
- Replies: 2
- Views: 1552
Re: Looking for help with the global machining receiver sections
I just got the number from someone who has done it before, the excessive length at the rear of a global machining repair section is 0.619 inch. This should be measured from the center channel where 2 halves joins (since the rear may not be perfectly square). With this number I can now mark everythin...
- Wed Jun 13, 2018 1:33 am
- Forum: MG42 Build It Yourself
- Topic: Looking for help with the global machining receiver sections
- Replies: 2
- Views: 1552
Looking for help with the global machining receiver sections
Hi everyone, I am a new member to this forum. I have read through a lot of the posts here about building the semi-auto MG42/M53, but I still didn't find the info to help with my specific situation. I have a M53 kit with everything and a set of "repair sections" from global machining (I know many peo...