Gripstick Cut Info
Posted: Mon Sep 03, 2012 10:23 am
I am seeing if anyone has any drawings on where to exactly cut the 42 Gripstick for the BRP ar15 trigger adapter
Steve
Steve
Page 1 of 1
Re: Gripstick Cut Info
Posted: Mon Sep 17, 2012 10:30 am
I would also like the cut locations.
Re: Gripstick Cut Info
Posted: Mon Sep 17, 2012 7:46 pm
It doesn't seem like anybody has them. How did everybody that used the adapter know where to cut their grip stick
Re: Gripstick Cut Info
Posted: Mon Sep 17, 2012 8:28 pm
Dr.J I have one that is machined at BRP. I will try to get some numbers for you. It is extremely pitted so I am going to mill my greek gripstick.
Re: Gripstick Cut Info
Posted: Mon Sep 17, 2012 10:44 pm
OK. here it is. You can see that the relief cut is very biased to the left side. I do no think this was intentinal. Also something to keep in mind is there is no relief for the trigger pin extension allowing trigger pack to sit low on the relief shelf. Anyway, I know its a crude drawing but best I could do while my son naps. RR 
Re: Gripstick Cut Info
Posted: Mon Sep 17, 2012 10:56 pm
Forgive the spelling. I was rushed.
Re: Gripstick Cut Info
Posted: Tue Sep 18, 2012 10:27 pm
I used a dremel and a mini mill to get mine where I wanted it. Test fit it a little at a time. Works great. Still had to trim the hammer and non critical part of the disconnect a little though.
Re: Gripstick Cut Info
Posted: Fri Sep 21, 2012 5:46 pm
Great guys thanks that really helps out a lot
Steve
Steve