MG34 Receiver Basic Dimensions

[762x51]

Here is a drawing showing the major dimensions needed for re-welds.
All NFA rules apply.

You can see the full size drawing here: http://www.autochart.com/MG34/MG34RecBasicDim.jpg

[rocco1911]

Thank you for posting this ...

[Bil]

Yes,thanks,Orin.I tried to do this once and made a mess of it. It will be handy when I try to figure out if I have enough material for a receiver. ---bil

[762x51]

Glad to help guys. Let me know if you need any other dimension.

Orin

[42rocker]

As said before MANY THANKS for posting this...

Sorry that I missed out on your mg42 receiver cut sale....

Thanks Later 42rocker

[crash520]

Thanks 762x51 for posting the good info

Does anyone know if any 34 rec ordnance drawings exist for all the dims of the 34 rec to scratch build one???

C

[42rocker]

There has been several good posts on this website about making one. However that said take a good look at the following website

http://www.tnwfirearms.com/photos.shtml

Note the equipment that they use to make the receivers. There has been talk about edm equipment and other things being used. I wish you a lot of luck.

Lots of folks buy several mg34 cut receivers and re-weld them...

Later 42rocker

[Bil]

for prints,try Maschinengewehr34.com Glenn Fahrquhar He sold some sets here,









i have one somewhere,but as mentioned above,the expensive machinery used would keep most from going the avenue. ---bil

[42rocker]

The set of prints that Fahrquhar put out are nice ones. Think long and hard before you think of starting to make a mg34 receiver from scratch. That said it's been done by several countries and at least one company.

Later 42rocker

[toolmanm203]

Does anyone have the front end blue prints for the cam location and rivet holes? Thanks.

[Abominog]

Interesting. As far as i can read blueprints this info is NOT in the J&G/ Farquist prints.

Would it not be in the TNW semi package?