installing the barrel

Jason · Post by **Jason** » Sat Apr 09, 2005 10:34 pm

I think I have a problem. I installed the recuperator but when I try to install the bbl I have to compress the head of the recuperator a little to get it started on the angled portion of the bbl. something does not seem right.

the recuperator is all the way back against the 'L' piece and the bolts are installed.

anyone encounter this before? or is it normal?

Post by **drooling idiot** » Sun Apr 10, 2005 12:15 am

the forward bolt that holds the front of the recuperator has a long side and a short , the long side goes facing the butt-stock I'm 99% sure.

Jason · Post by **Jason** » Sun Apr 10, 2005 9:57 am

thanks. I think that I have it facing to the rear but I'll double check.

Post by **Reichpapers** » Sun Apr 10, 2005 6:12 pm

Is your bolt to the rear when installing the barrel?

Jason · Post by **Jason** » Sun Apr 10, 2005 8:01 pm

yep, the bolt in the front of the recuperator was facing forward. kind of a dumb mistake because somewere it was posted that it went in pointing to the rear. lesson learned. thanks for the info